Yahoo Answers is shutting down on May 4th, 2021 (Eastern Time) and the Yahoo Answers website is now in read-only mode. There will be no changes to other Yahoo properties or services, or your Yahoo account. You can find more information about the Yahoo Answers shutdown and how to download your data on this help page.

Lv 2502 points

Jimmypockets

Favorite Answers9%
Answers120
  • steering colum turn signal switch 1967 impala no tilt with console shift .?

    replacing signal switch and I can't seem to line up the holes for the screws. I had it once then removed them they won't grab the threads they are not stripped . hard to see throught the hole to line up. Am I not doing something I should be doing ? I want to complete this so I can move on to replacing dash Wiring harness .

    thank you in advance for any suggestions

    1 AnswerMaintenance & Repairs6 years ago
  • 1986 Evinrude 90 Shes running really rough?

    evinrude outboard motor repair Evinrude 90 trying to get to run right some help Please.. runs real rough and backfire

    86 Evinrude 90 just purchased cheap and I don'want't to throw good money after bad any help would be greatly appreciated.

    owner said ran good till it sat. I'm more of a part changer than a mechanic but I do have the manual and did stay at a HowarJohnson'sns LOL

    Ok It had no spark on thPort sidede was running on 2 cylinders. When I moved power Pack to left side It had Spark so I ordered a new one from here and some carb kits .

    I put te power pack on tonight and It has spark on all four cylinders.

    I put a new set of plugs in it and fresh fuel . started it up still runs rough and left plugs seem much cooler she backfires runs rough and shakes.

    So I figured I'd give it a compression test results as followPort sidede top =80 bottom=83 Starboard top=70 bottom =70 low but they don't seem that far off from each other. So what's the next move Carbs? Timing? I'm getting lil Stumped any suggestions welcome

    4 AnswersBoats & Boating10 years ago
  • Old Montgomery Ward Snowblower 5 hp by Gilson Manual ?

    Does anyone know a link or where I can get a manual for gil 35211b wireing diagram or manual for montgomery ward briggs 5 hp snowblower. model gil 35211b . No spark replaced points plug condensor and coil . kill / safety switch fell apart and not sure which wire goes where or how to bypass

    any good input here ?

    thanks

    3 AnswersMaintenance & Repairs1 decade ago
  • should I leave my marriage?

    I been married for 19 years and have 2 children 13 and 16. I love my wife very much. My wife never pays attn to me and we have been to counseling at my request. She is not affectionate and leaves me starved for affection. I make 6 figures. She has gone most of our marriage to school .She enrolled without even discussing it with me . In counseling she admitted that she didn't because I might talk her out of it. this is the second time she went to school during our marriage and I am very resentful towards her schooling. She mostly sleeps on the couch at night and I go to bed early and sometimes I wake up and she's next to me . She is very busy between kids and school that never has time for me , I know she needs affection because I see her hug my children.She never calls me unless she needs something.

    Recently I got caught cheating on her It was 1 date and 1 kiss. she saw the text message because I left my phone home the next day. I think subconsciously I wanted her to catch me. Now she says she doesn't trust me . What is weird is besides being a little more distant nothing has changed and she didn't throw me out.

    She graduates in June and I wanted to leave 6 months ago but didn't want to screw up her schooling.

    I'm thinking she will throw me out or ask me to leave when she gets her degree

    Sorry to be a little vague

    6 AnswersMarriage & Divorce1 decade ago
  • headlight fuse 93 Chevy Silverado?

    headlight fuse 93 Chevy Silverado . Where is the exact location . I know where the fuse block is but doesn't say which one. The haynes book just shows picture of block but not labeled some of mine are blurred Headlights are not working . Both I would assume fuse or relay .

    8 AnswersMaintenance & Repairs1 decade ago
  • automotive Chevy Silverado 4x4 wont go in 4wd was in yesterday and was working fine?

    Chevy 1993 Silverado 4x4 wont go in 4wd was in yesterday and was working fine then I noticed I got stuck and 4wd wasn't working but was lit that it was.

    but I can tell it's not engaged . Nothing broke or anything . No shaft hanging or snapped.

    I'm assuming it is the accuator .

    I just ordered a new one hoping it will fix the problem. any input would be helpful

    thanks in advance

    1 AnswerMaintenance & Repairs1 decade ago
  • Mathamatical procedure I figured this out already but I forgot how?

    If 3 people on the job all get paid but it only requires 2 people there at all times. How do you figure out how many hours each work and each are on break for example 21 hr shift. I think it was something like take the shift double the hours= 42 divide by 3 or something the rest I forgot . we need to work this out fairly so no one person gets screwed I think you take the remainder split it in half and thats your break . Something like work 13hrs each and 3 1/2 hour break each. sorry for grammer im in a hurry to get back to work LOL

    thanks

    2 AnswersMathematics1 decade ago
  • 97 lexus es 300 O2 Replacement fault code po 136 bank 1 sensor 2 replacement?

    I just tried to replace the sensor that is right by the CAT. The connector wire was long and I noticed the connector must be under the floor? in the body of the car? It seemed like a longer than normal wire. Anybody know how to get to that clip? I can change the sensor but reaching that clip seems a bit far. also does anyone know the toyota part # for that sensor?

    1 AnswerLexus1 decade ago
  • Firearms legal Ques Connecticut?

    Does Anyone know what could happen if you are a licensed firearms owner in New jersey , Had Magazine in gym bag from range didn't realize went to Connecticut no gun though, then lost it , but was found and turned into police , then called where I was to see if found was told it was found and turned in . then I called police and they said they have it and bring paperwork to pickup , Which is fine . but the real ques is can I be in trouble for this?

    thank you

    1 AnswerLaw & Ethics1 decade ago
  • Jenn Air Microwave Convection JMV9169BAP Does Not Heat Food in Microwave Mode?

    The convection works the fan and ,keyboard . It turns on except it does not heat the food after trying a few times the power will go out then come back on thirty minutes later, Product is new but sat for a few years and the serial # sticker is gone and Jenn Air wont fix it Voided waranttee .It is on a dedicated twenty Amp circut. any way to fix this I'm pretty handy

    thanks

    2 AnswersMaintenance & Repairs1 decade ago
  • 2000 Jetta 2.0 5 speed wont run Right Check Engine P-0300 P-0302 P-0303 P-0304 HELP HELP TRIED EVERYTHING?

    I just purchased 2000 Jetta Check engine light is on . Code reader comes up misfire P-0300 P-302 P-303 P-304 The guy said it was the wires he lied. My friend is very good with VW's he looked at the other day he's stumped. We changed wires, pulgs , coil Pack, fuel filter, checked Mass air flow, checked timing mark, and belt , and for vacume leaks, the car runs smooth he doesn't think it's valves. The car Idles pretty smooth then you feather the gas and get it up there it runs pretty smooth but she wont rev like there is a blockage or something ,he said maybe the crank sensor or maybe someone pressure washed the engine and got the ECM wet , he only had limited time to look the other day.He said its getting fuel pressure we must be over looking something stupid. I feel like strangling the dealer that sold it to me because I saidI didn't have much money left over, Now he doesn't awnser my calls, HELP HELP

    3 AnswersVolkswagen1 decade ago
  • Need Help VolksWagon 2000 Jetta 2.0 DTC codes PO-300 PO-302 PO-303 PO-304 BAD MISS?

    I Just purchased the car.2.0 5 speed these codes came up . on coil pack I sprayed water on coil pack because when I changed wires a little piece cracked/came off car had to be driven home from Fla to N.J. that sucked! the wire covered the boot where a little piece came off then I put permatex on it so in case it rained it wouldn't be a nightmare now I'm home I sprayed water on wires and coil pack and I see no ark so then I sprayed gumout to check for vacume leaks idle did not change , I;m trying to figure this out I'm thinking Air flow meter. Does any one know what could possibly cause this Does anyone know where I can download a free pdf repair manual, I'm not a mechanic but a very good part changer

    sorry about the font all I did was hit spell check

    1 AnswerVolkswagen1 decade ago
  • Advice needed Mercruiser 260 Alfa One inboard 615 hrs?

    [I][B] I'm purchasing a 20' Celebrity with a Mercruiser 260 Alpha one inboard it has 615 hours it is a project to me the bottoms pretty crusty that's not a problem to me. But the 615 hours seems like a lot . I am mechanically inclined it seems I was assuming even if it runs which it is winterized it will need a rebuild, What I wanted to know what can I expect in the neighborhood of hours can be gotten out of this motor, and what should immediately should be done to it. the owner said he did rebuild the outdrive and gimble bearing two years ago. I was looking for where you can purchase inexpensive engine rebuild kits or can this be replaced with a regular Chevy 305 car motor I am purchasing this package for around a thousand dollars so I figure I cant go wrong. I just didn't want to spend like four thousand or an engine any suggestions t

    thank you[/B][/I]

    8 AnswersBoats & Boating1 decade ago
  • ( Plumbing) What is the proper way to snake outside drain?

    ( Plumbing) What is the proper way to snake outside drain, from house to street I believe it is clogged from tree roots. A tree is growing in direct line of pipe to street, Roto Rooter wanted 400.00 to snake it, I was going to rent an electric snake and attempt to do myself Ivedone a lot of my own repairs I just never used an electric snake before. Help

    2 AnswersMaintenance & Repairs1 decade ago
  • Diagnosis needed Runs Terrible stalls in Rain 1997 Acura TL 2.5 ?

    I have a 1997 Acura TL 2.5. Problems occur when it is raining, it does not seem to idle correctly and when trying to rev it makes some pops it also seems to idle erratically, but on the open road or on the highway it is fine in the rain. I have been told that moisture is most likely getting in there. I have changed the distributor cap and rotor. I have changed the wires and plugs. I coated two sensors, near the coil with household silicone and some of the sensors I started to put dielectric grease. The problem still exists. I am going to take off the distributor cap again and inspect. I would like to reseal the cap back on with some silicone to make sure and 100% eliminate that problem. I know changing the distributor cap on this car is nightmarish. The car does have 201,000 miles on it. Otherwise it seems to run and idle perfectly when it is not raining. I did not install an OEM distributor cap, I do not know if it really makes a difference, but I like this car and if anyone can help with some suggestions. I work on this vehicle myself and I am sure this could get pretty expensive at the dealer. Also, the CD player does not play CD’s a code comes up that I believe says CPEO. I also installed a new air filter. I do not believe it could be a dirty fuel filter because wouldn’t it run badly all the time.

    1 AnswerMaintenance & Repairs1 decade ago
  • Acura Tl 2.5 1997 Runs like Crap in inclimate weather?

    Acura Tl 2.5 1997 Runs like Crap in inclimate weather. I put obll code reader on came up PO-200 a radio code means nothing. I replaced Air filter, distributor cap,rotor,and wires. still bad, then I put a garden hose on it near the coil area it seemed to start running bad but then it didn't seem to go away,I unplugged a few connectors to look for moisture then check engine light came on. I reconnected obll code reader now it comes up error. I'm stumped? I want to disconnect and reconnect the ECM on passenger side but I can't seem to find it someome said under carpet. Right now I'm trying to let dry out. Any help out there I'm ready to when it hopefully dries out coat each connection with silicone

    2 AnswersMaintenance & Repairs1 decade ago
  • 97 Acura TL 2.5 ECM Where is it located?

    97 Acura TL 2.5 ECM Where is it located Car runs like crap when it rains.

    2 AnswersAcura1 decade ago
  • How do you install VSS sensor for transmission 2000 CadillacEldorado Code comes up PO502 not the sensor inside?

    How do you install Vehicle Speed Sensor .VSS sensor for transmisson 2000 Cadillac Eldorado not the one thats inside the transmission. The one by the right front wheel..

    2 AnswersMaintenance & Repairs1 decade ago